Broadcast Tools DSC-20 Manual de instalación descargar pdf (Pagina 41)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

correct. If the code is not entered within 30 seconds, Smarttouch hangs up. If the code is

entered correctly within that time frame, you will hear air cue fed back down the line.

This tells you that you are now connected to the Smartcaster.

At this point, the Smarttouch waits for the next 3 digits, and will interpret these three

digits as the remote number.

For example, if you punch 001 on the touch-tone phone, the unit will access remote

number one, while a 123 on a touch-tone phone will access remote number 123. If you

make a mistake, continue to enter until all three digits are in place, wait a few seconds,

then enter the correct number. You must keep track of your keystrokes here, since you

cannot see the Smartcaster screen. Enter the three digits carefully and you will be ready

to broadcast.

Use the "#" key to clear the Smarttouch much the same as you would clear a calculator.

This will set the network back to air and send the Smartcaster to the "Satellite on Air"

screen. From here you can re-enter your remote number and start over.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 56 57

Sin comentarios

Broadcast Tools DSC-20 Manual de instalación Pagina 41