Broadcast Tools DSC-20 Manual de instalación descargar pdf (Pagina 21)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

Fig. 1.2. The back panel of the RIDZ Switcher showing

The J1 Connection and the grounding post.

On the back panel, the control cable from the SMARTCASTER will attach to the J1

Connector. The connector is snug, and is notched so it will only fit in one way. The

wing locks should be secured to make sure the connector is tightly fastened.

The Ground Post is above the J1 Connection. The grounding wire may be wrapped

around the post or inserted into the hole in the post. The ground wire may then be

secured by tightening down the green plastic fastener.

The channel inputs and Program and Record Outputs are located in the middle of the rear

panel. Channels one through five are on the top row, and six through nine are on the

bottom row. The outputs are also located on the bottom row.

Fig. 1.3. The back panel of the RIDZ Switcher showing the channel

connections and outputs.

The power connection is on the far right. The power supply is 24 volts DC.

Anything routed through the first eight inputs can be switched to either PRGM OUT or

REC OUT. The RIDZ may be controlled three different ways. Typically, it is controlled

on a timed basis from the Timed Events screen of the SMARTCASTER. It may also be

controlled from the keyboard by pressing the ALT + F1 keys at the same time. A screen

will appear that presents a choice of channels. Selecting a channel number and pressing

Enter will cause the switcher to change channels. Choices one through eight will put

networks ( inputs on the back of the switcher ) one through eight on the output of PRGM

on the RIDZ (to air). Choices nine through sixteen will put the same networks to the

REC output of the RIDZ (to record). The other three choices are: 17 (Clear Air ) which

clears channels one through eight from being routed to air. 18 ( Clear Record ) will clear

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 56 57

Sin comentarios

Broadcast Tools DSC-20 Manual de instalación Pagina 21