Satellite sources-Audio
In the appendix of this document is a section on some satellite receivers. The audio from
these and other sources needs to be wired to the RIDZ switcher. It is recommended that
this wiring be done for any source that you expect the computer to route either to air, or
to the record bus. Please consult the section of this manual called “Wiring the RIDZ” for
specifics on this step. Pay close attention to the parts about balanced and unbalanced
audio.
Extra hot audio sources
There is still audio gear in many radio stations that have really hot outputs, like + 10 or
more dB! Because you are mixing sources from –10 into the system, sometimes these
extra hot sources will BLEAD into you audio on other channels, padding these sources
down to a true 0 dB may be easier than trying to align all the other sources to match.
Again either use an H PAD for balanced audio or purchase an adjustable device like the
STP-1 from RDL.
For 600 ohms, a 10dB “H” pad will have 150 ohm resistors in the four arms, and the
cross resistor will be 422 ohms. For 20 dB, the arms are 250 ohms, and the cross is 121
ohms.
You can find a calculator for building “H” pads at:
http://www.mcsquared.com/dbframe.htm
http://www.discovercircuits.com/resources/calculators.html
is another web site with many other useful calculators.
Satellite sources-Closures
See the RIDZ section later in this book for information on connecting tone decoders and
relay closures to the 780 boards.
Software setup and testing
Console audio
Broadcast Console is a term that can range from a simple under 100 dollar mixer, to an
all digital beast costing over $20,000, so it is difficult to get very exact about what to
hook up to it, but here are some common situations.
“I am fully automated all the time, I just need to get on the air live in special situations.”
Comentarios a estos manuales