Broadcast Tools WVRC-8 Especificaciones descargar pdf (Pagina 9)

e-mail:

[email protected]

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

INSTALLATION

Name Type Description

ST1A - 8A Connector Status opto-isolators.

When configured for DRY (factory default) this ter-

minal is ground. When configured for WET (floating),

this terminal is the anode via a 2.2K ohm current lim-

iting resistor. (BOTTOM)

ST1B - 8B Connector Status opto-isolators.

This terminal is always the cathode (BOTTOM)

K1NC - K4NC Connector Normally closed, dry relay contacts. Raise function

(TOP)

K1CM - K4CM Connector Common (wiper), dry relay contact. Raise function

(TOP)

K1NO - K4NO Connector Normally open, dry relay contact. Raise function

(TOP)

K5R - K8R Connector Normally open, dry relay contact. Raise function

(TOP)

K5R - K8R Connector Common (wiper), dry relay contact. Raise function

(TOP)

K1NC - K4NC Connector Normally closed, dry relay contact. Lower function

(BOT)

K1CM - K4CM Connector Common (wiper), dry relay contact. Lower function

(BOT)

K1NO - K4NO Connector Normally open, dry relay contact. Lower function

(BOT)

K5L - K8L Connector Normally open, dry relay contact. Lower function

(BOT)

K5L - K8L Connector Common (wiper), dry relay contact. Lower function

(BOT)

CONFIGURE Dipswitch Used to configure the unit. Refer to table of contents.

TEMP 3.5mm Jack Temperature probe input jack. T/R/S.

PF 2.1mm Jack Power Failure power jack (optically-isolated). 6 - 12

VDC,center positive.

BT-LINK Dual RJ45’s RJ45, used for future system expansion.

12VAC 2.1mm Jack System power supply input. 12 volts AC.

GND # 6 screw System ground screw. Tie to station ground system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 40 41

Comentarios a estos manuales

Sin comentarios

Broadcast Tools WVRC-8 Especificaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Broadcast Tools WVRC-8