Broadcast Tools WVRC-8 Especificaciones descargar pdf (Pagina 27)

e-mail:

[email protected]

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

SETUP

4 - Start the “Device Installer” software.

a - Click on “SEARCH”

b - When the WVRC-8 is found, click on the listed device. If more than one WVRC-8 is

found, refer to the MAC address label attached to the WVRC-8 RJ-45 case and click

on the desired WVRC-8, which should be highlighted.

NOTE: Locate the MAC address label attached to the top of chassis.

c - Click on the “ASSIGN IP” button, then follow the instructions for setting a static IP

address, along with the subnet and gateway, if applicable.

d - After rebooting the WVRC-8, set you computer IP setting back to it’s original settings

and access the WVRC-8 at it’s new address or click the “SEARCH” button, the con-

figured WVRC-8 should be listed.

NOTE: You may have to click the search button more than once after the reboot.

NOTE: You can also open your browser and type in the assigned IP address in the

“ADDRESS” area of your browser. Example: 192.168.1.101

5 - If you are behind a firewall or router, you will need to port forward not only port 80,

but also open ports 3001, 3002, 10001 and set the SUN Java to direct.

NOTE: To set up port forwarding, refer to the manual supplied with the firewall or

router.

6 - To change the WVRC-8 from port 80, contact the factory

7 - To access the WVRC-8, open your browser and type in the assigned IP address in the

“ADDRESS” area of your browser. Example: 192.168.1.101

NOTE: We recommend using the latest version of the FireFox or Safari web browser.

8 - If things are working correctly, you should see the WVRC-8 web page.

NOTE: On some machines and browsers, this may take a few seconds.

9 - Log in using the default: user name

either wvrc8 or admin (lower case)

and password

: either wvrc8 (lower case) or 1234

NOTE: If you change the user name and password, be sure to write it down.

10 – Follow the descriptions on the following pages to set up the WVRC-8.

The WVRC-8 software consists of two components – firmware running in the

Xport and a Java applet hosted on the Xport, running in a web browser. This

document describes the operation of both components.

WEBSITE:

Visit our web site for

product updates and

additional information.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 40 41

Comentarios a estos manuales

Sin comentarios

Broadcast Tools WVRC-8 Especificaciones Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Broadcast Tools WVRC-8