Broadcast Tools WVRC-8 Especificaciones descargar pdf (Pagina 23)

e-mail:

[email protected]

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

OPERATION

Dial Up Operation

When the WVRC-8 is called, it will answer on the number of rings programmed. When it answers,

enter the security code, which in this example is the default 123. The access LED will turn on

once a valid security code is entered and the “Access Accepted” Message will play. After a valid

access code is received, the addressed unit will a generate DTMF “AB” which will cause any other

units in parallel to hang up.

Raise and Lower Relays are controlled with single digits 1-8 followed by * for Lower or # for

Raise. Once a single channel number has been entered, you can enter * or # to operate the select-

ed channels raise and lower relays until a new channel number has been entered. The analog

(metering) value for the selected channel will play each time a number between 1 and 8 is entered

as long as DIP3 is off.

Example: Enter 1 – analog (metering) value 1 will play - * - The number 1 Lower relay will close

for as long as “*” is received. # - The raise relay will close for as long as “#” is received. If DIP3

is OFF, the associated relay message plus “raise” or “lower” will be played after the * or # is

released. To query the new analog (metering) value, press 1 again to repeat the value.

Audio I/O functions are controlled with the following codes, once the security code has been

entered:

01 – Local MIC Monitor ON / Feeds the local mic audio to the phone line.

02 – Local MIC Monitor OFF / Turns off feed.

03 – Telco Caller Audio Output ON / Feeds phone line (CALLER) audio to the (CLR -/+) output

terminals.

04 – Telco Caller Audio Output OFF / Turns off feed.

05 – Telco Send audio input ON / Feeds send (SND -/+) audio to the phone line.

06 – Telco Send audio input OFF / Turns off feed.

07 – SS monitor audio to telco ON / Feeds Silence Sensor source audio (SS-LT/SS-RT) to the

phone line.

08 – SS monitor audio to telco OFF / Turns off feed.

The status inputs, analog (metering) inputs, silence sensor, temperature and

power fail inputs can be polled by entering the following codes.

Polling Silence Sensor Alarm: 910

Polling Status inputs: 911 - polls input 1, 912 - polls input 2 …. 918 polls input 8.

Polling Power Failure: 919

Manual Hang-up: 920 will cause the WVRC-8 to hang up.

Polling Analog (metering) inputs: 921 - polls analog (metering) input 1, 922 - polls analog

(metering) input 2 ….. 928 polls analog (metering) input 8

Polling temperature: 929

DTMF Control of Alarm Enable Registers 97, 98 & 99)

All of the alarm call-outs can be enabled, disabled or polled remotely using DTMF control. First

enter the access code.

WEBSITE:

Visit our web site for

product updates and

additional information.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 40 41

Comentarios a estos manuales

Sin comentarios

Broadcast Tools WVRC-8 Especificaciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Broadcast Tools WVRC-8