Broadcast Tools WVRC-8 Especificaciones descargar pdf (Pagina 12)

e-mail:

[email protected]

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

INSTALLATION

Telco Caller Audio Output

Connect your input equipment to the balanced (CALLER) output. The output terminals

are labeled “CLR –“/“CLR +” and GND. The level may be adjusted on the rear panel

trimmer labeled (telco) CALLER. For unbalanced loads, use the “+” and GND terminals

only. Do not connect the “- or +”

terminal to ground.

TEMPerature Probe Input

Insert the temperature probes (25 foot cable) mini (3.5mm) plug in to the rear panel jack

labeled “TEMP” (-40°F to +190°F (-40°C to +85°C).

NOTE: Please limit the total length of cable to 50 feet. Please contact the factory for the

proper extension cable. The Probe should only be installed or removed with the power

supply disconnected from the WVRC-8.

Front Panel Microphone

No setup is needed. The microphone pre-amp is equipped with an AGC circuit providing

acceptable site monitoring levels (dial-up mode only).

BT-Link RJ-45 Connectors Future product expansion.

POTS Telephone Line RJ11

Connect one end of the supplied RJ11 modular cable to the rear panel RJ11 jack

labeled “LINE” and the other end to the telephone line.

NOTE:

Some “cell phone services” severely distort DTMF control tones resulting in

unreliable control. If you plan on using the cellular system for your POTS connection,

you may have to experiment with various service providers to get reliable control. With

some cellular phone services, you may need to change the DTMF guard time jumper JP3

to the “FAST” position.

We recommend using the following products from Telular “Phonecell® SX5D or SX7”

system (

www.telular.com/).

PGM, RJ11, TT phone

Connect the modular cord of the user supplied TT telephone to the rear or front panel

RJ11 jack labeled “PGM”

PGM, RS-232 female DB-9 connector

Connect one end of the supplied male/female straight-thru serial cable to this connector

and the female end to a user provided PC (this may not be needed if the user elects to pro-

gram the dial-up portion via telnet (INTERNET).

NETWORK connector

Connect one end of the supplied CAT5 (straight or xover) cable to desired ETHERNET

(WAN/LAN) port.

POWER connector (12VAC)

Connect the supplied 12VAC power supply cord in to the WVRC-8’s power jack labeled

“12VAC 1 AMP”, then plug the transformer in to a source of 120vac 60Hz. Verify that

the front panel green power led is illuminated.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Comentarios a estos manuales

Sin comentarios

Broadcast Tools WVRC-8 Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Broadcast Tools WVRC-8