Broadcast Tools ProMix 12 Especificaciones descargar pdf (Pagina 7)

ee--mmaaiill::

[email protected]

vvooiiccee::

360.854.9559

ffaaxx::

866.783.1742

ProMix 12 Installation and Operation Manual

SETUP

2.3 POWER INPUT

Plug the console’s external power supply into the Power jack (11). Do not use any

power supply not supplied with the console. The power supply is a “universal input”

type, and can be used with any AC input voltage between 100 and 250 VAC, either

50Hz or 60Hz. No changes to the power supply are needed. The AC mains cord

must have a connector appropriate for the AC socket being used.

3.0 ADJUSTMENTS AND SETUP

3.1 GAIN ADJUSTMENT

Each of the 3 microphone input channels has a GAIN adjustment (12) to optimize

the microphone preamp gain for the microphones being used. The gain can be var-

ied over a 20dB range. Use a small screwdriver to adjust the gain trimmers as need-

ed. Microphone gain is properly adjusted when the preamp output (accessible via

the TIP of the Microphone Process Insert (2) T/R/S jacks) is about –10dBm when

speaking into the microphone. To quickly set microphone gain, follow these steps:

1. Assign the microphone channel to the Program bus.

2. Set the microphone channel fader to –15db.

3. Speak into the microphone; set gain so that voice peaks read about 0VU on

the console VU meters.

3.2 MICROPHONE CHANNEL MONITOR MUTE PROGRAMMING

The console’s Monitor system can be programmed so that when Microphone 2

and/or Microphone 3 are on, the audio output from the Monitor system is muted. If

Microphone 2 or Microphone 3 is located in the same studio as the Monitor speak-

ers, the Monitor system should mute to prevent acoustic feedback when the

Microphone is ON. Programming Microphone 2 and/or Microphone 3 to mute the

Monitor system is done by installing jumper wires on the Microphone 2 & 3 Remote

Control connector (9). See Figure 2. To enable Microphone 2 monitor mute, install

a jumper between pins 3 & 11(see note below). To enable Microphone 3 monitor

mute, install a jumper between pins 7 & 11 (see note below).

NOTE: On version A & B, jumpers JP2 (Mic-2) and JP3 (Mic-2) may be

installed on the main circuit assembly (the bottom cover must be removed to

access these jumpers), eliminating the need to solder jumpers on the connector.

WEBSITE:

Visit our web site for

product updates and

additional information.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comentarios a estos manuales

Sin comentarios

Broadcast Tools ProMix 12 Especificaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Mezcladores de audio Broadcast Tools ProMix 12