Broadcast Tools ProMix 12 Especificaciones descargar pdf (Pagina 6)

ee--mmaaiill::

vvooiiccee::

360.854.9559

ffaaxx::

866.783.1742

ProMix 12 Installation and Operation Manual

INSTALLATION

2.2 CONTROL INTERFACE

2.2.1 MICROPHONE 2 & 3 REMOTE CONTROL

The console provides for remote control of Microphone 2 and Microphone 3 via the

Microphone 2 & 3 Remote Control connector (9). This 15-pin D connector should

be wired according to Figure 2.

Note that “cough switches” for microphones 2 & 3 can be installed for use by the

console operator if these microphones will be used in the studio. If these cough

switches are not used, jumpers (see note below) must be installed as shown between

pins 9 & 10 and between pins 13 & 15. Mics 2 & 3 will not operate if these jumpers

are missing.

Cough switches can also be installed for remote use, as shown connected to the

remote ON switches. If the “cough switches” are not used, jumper wires must be

installed in their place (See note below).

NOTE: On version A & B, jumpers JP1 (Mic-1) and JP4 (Mic-2) may be

installed on the main circuit assembly (the bottom cover must be removed to

access these jumpers), eliminating the need to solder jumpers on the connector.

LEDs can be used to show “Microphone ON”; be sure to include the 1K resistors as

shown. (This value can be changed to set LED brightness.)

The Talkback function allows the booth announcer to talk directly to the console

operator (off-air) via the Talkback system.

The MUTE TALLY relay on pin 4 (ground is pins 1 & 5) provides a means of

switching external equipment when the monitor mutes. The relay contact goes to

ground when the monitor is muted. It can be used to operate “ON AIR” warning

light controllers, etc. Contact rateing are 30vdc @ 1amp or less. DO NOT

EXCEED THIS RATING. NEVER CONNECT THESE CIRCUITS TO A 110

VOLT AC LINE!

2.2.2 LINE CHANNEL REMOTE CONTROL

The console provides 9 momentary SPST switches than can used for “remote start”

of line channel source equipment, e.g, CD players, tape decks, etc. Interface to these

switches is via Line Channel Remote Starts connector (10), a 25-pin D connector.

WARNING: The maximum voltage that can be applied to Remote Start switches is

24vdc @ 100ma or less. DO NOT EXCEED THIS RATING. NEVER CONNECT

THESE CIRCUITS TO A 110 VOLT AC LINE! Connect the mating 25-pin D con-

nector according to Figure 3.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sin comentarios

Broadcast Tools ProMix 12 Especificaciones Pagina 6