Broadcast Tools ProMix 12 Especificaciones Pagina 4

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 3
ee--mmaaiill::
vvooiiccee::
360.854.9559
ffaaxx::
866.783.1742
4
ProMix 12 Installation and Operation Manual
INSTALLATION
2.1.3 LINE INPUTS
The ProMix 12 accommodates up to 9 stereo “line level” sources. Source equipment
can be either balanced or unbalanced, operating at either professional (+4dBm) or
consumer (-10dBm) levels. It is connected via the Line Input T/R/S jacks (3). The
upper jacks are for Left channel inputs; the lower jacks are for Right channel inputs.
Mating TRS plugs should be wired as followed:
Unbalanced sources: TIP: Hi (or “hot” lead)
RING: (leave unconnected)
SLEEVE: Ground (or shield)
Balanced sources: TIP: Hi
RING: Low
SLEEVE: Ground
Note: The console terminates the Low input to ground via a 1K resistor. In
some cases, connecting the Low audio lead to Ground will produce a slightly
higher audio level. However, check the manual of the source equipment to be
certain grounding the Low output lead will not cause problems. It is general-
ly OK to do so on older transformer-coupled outputs; active (transformerless)
outputs may or may not permit this.
2.1.4 USING A TELEPHONE HYBRID
If the console will be interfaced to a telephone hybrid (for broadcasting telephone
calls), the Receive (“caller”) output of the hybrid should be fed into Channel 4. This
is because the Mix Minus output of the console contains ALL line sources mixed to
the AUDITION bus, except for Channel 4. The” Audition-minus-caller” Mix Minus
output is normally fed back to the hybrid’s send input. The caller will therefore be
able to hear all program sources mixed on the Audition bus, minus him.
2.1.5 AIR MONITOR INPUT
The console provides a Monitor Air input (4) that can be used to feed an off-air mon-
itor into the console’s Monitor system. This input is electrically identical to the
other Line channel inputs, and should be connected the same way. Any tuner or
demodulator can be used.
Vista de pagina 3
1 2 3 4 5 6 7 8 9 ... 19 20

Comentarios a estos manuales

Sin comentarios