Broadcast Tools SS 4.1 III Manual de usuario descargar pdf (Pagina 37)

It's possible to 'zoom-in' on the waveform in various ways by clicking the

Amplitude and Time buttons. By default, the waveform is displayed fully 'zoomed-

out', thus showing the entire length of the audio cut. The GoTo buttons can be

used to jump directly to the current play out cursor position, start or end of the

waveform.

Audio can be played one of two ways: either by clicking on the waveform to

indicate where play out should start and then clicking the left-hand Play button,

causing play out to start from the selected position, or by clicking the right-hand

Play button, which will cause play out to start from the Start Marker (just as it

would in RDAirPlay). Clicking the Pause button while playing will cause audio

to stop and the play out cursor (a thin vertical black line in the waveform area) to

freeze at its current position, while pressing the Stop button will stop the audio

while resetting the play out cursor to the position it was in when Play was started.

Clicking the Loop button will cause the audio to play out continuously, looping

from end back to start, until either the Stop, Pause, Save or Cancel buttons are

clicked.

Illustration 10: The Edit Markers Dialog

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Sin comentarios

Broadcast Tools SS 4.1 III Manual de usuario Pagina 37