ee--mmaaiill::
vvooiiccee::
360.854.9559
ffaaxx::
360.854.9479
3
ProMix 12 Installation and Operation Manual
DESCRIPTION
DESCRIPTION
The ProMix 12 is a full-featured audio mixing console ideally suited for the typical
broadcast studio or any similar application. It features inputs for 3 microphones and
9 stereo line sources, two stereo mixing buses, a “mix-minus” output, a mono out-
put, and comprehensive cue and monitoring systems. Other functions include an
announce booth output with full duplex talkback, accurate audio level metering,
remote control of mic channels and remote-start facilities on all line input channels
INSTALLATION
(See Figure 1 for connectors and controls (x) referenced in the text.)
AUDIO CONNECTIONS
MIC INPUTS
The ProMix 12 has inputs for up to 3 microphones. Microphones should be low-
impedance professional units with balanced outputs. Dynamic microphones are
suggested. Powered condenser microphones can be used, although the console does
not provide phantom power. Connect microphones to the female XLR connectors
(1) on the rear of the console. The mic plug should be wired as follows:
PIN 1: Ground
PIN 2: Hi
PIN 3: Lo.
MIC PROCESS INSERT
The ProMix 12 provides for the insertion of external microphone processing equip-
ment, e.g, a mic limiter or equalizer. External mic procession equipment should be
interfaced via the TRS Mic Process Insert jacks (2). These jacks provide a means of
inserting processing gear just after the console’s mic preamps, but before the mic
channel faders. The mic preamp output and return circuits are unbalanced, at a nom-
inal level of –10dbm. Wire the mating TRS plug as follows:
TIP: To processor input (from mic preamp output)
RING: From processor output (to console fader input)
SLEEVE: Ground.
LINE INPUTS
The ProMix 12 accommodates up to 9 stereo “line level” sources. Source equipment
can be either balanced or unbalanced, operating at either professional (+4dBm) or
consumer (-10dBm) levels. It is connected via the Line Input TRS jacks (3). The
upper jacks are for Left channel inputs; the lower jacks are for Right channel inputs.
Mating TRS plugs should be wired as followed:
WEBSITE:
Visit our web site for
product updates and
additional information.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales